Tview T712HR-IR - Manual (Page 3)

03 04
1. Pow er: Turn on /off po wer
2. : Pres s the m to inc rea se an d de cr ea se the bri gh tne ss.
3. COL: Pres s the m to inc rea se an d de cr ea se the co lor.
4. : Pres s the m to inc rea se an d de cr ea se co nt ras t.
5. : Pres s it to se lec t the mod e
(st an da rd, ligh t, so ft, vi vi d, mem ory)
6. Rev erse: Turn the pi ct ure from lef t to righ t or up to do wn.
7. V1/ V2: AV1/ AV2 to sw itch
POWER
COL
1
2
3
4
SYS
V1\V2
5
6
7
Remote Control
The above functions can be executed by MENU on the display
or remote control unit.
Press the MENU of unit , you can choose “BRIGHT”
“COLOR” “CONT” “TINT(ONLY NTSC SYSTEM)”
“LANGUAGE” “SCALING”, then press “+” “-” on the unit to
adjust that you need. Or press / col / “ ” “ ” on the
remote control directly adjust “BRIGHT” “COLOR”
“CONT”
.
.
.
.
Precautions before using remote control unit
AV Display Mode:
Remote control unit operating range
6
1.
Replacing the battery
2.
3.
Operating method: Press the button “V1/V2” on the remote
control or the unit to choose AV display mode. If the VCD or DVD
signal is connected, there should be display normally pictures
signal; If the VCD or DVD signal isn't connected, the screen is
blue. the system will display “NO SIGNAL”.
1. BRIGHT
2. COLOR
3. CONT
4. TINT(only NTSC system)
5. LANGUAGE
6. SCALING(16:9/4:3)
IR: The machine equipped with IR audio transmitter, frequency
(2.3MHZ, 2.8MHZ), please choose a suitable infrared
receiver headset answering, receiving distance in a straight
line within 3 meters
IR emission from AV1/AV2 audio control, as long as the boot,
with the audio input can be launched