TVLogic LVM-095W-N - Manual (Page 9)

Multi Format LCD Monitor 9
LVM-095W : FRONT
3. Controls & Functions
• [MENU] Button
- Used to activate the OSD menu.
- When the OSD menu is activated, press this
button to exit from the menu.
• [UP] / [DOWN] Button
- Used to move within the menu when the OSD
menu is activated and is also used to increase
or decrease the value of selected feature.
• [ENTER] Button
- Used to select the feature of main menu and
the sub menus.
• [POWER] Switch
- Used to turn the power on and off. If the signal
is normal, Green LED light is indicates. If the
signal is unsupported or disconnected, LED
light flashes in Yellow.
• [STANDBY] lamp
- Used to indicate the power supply status.
The lamp is RED during power supply and
GREEN during system is in operation. In case
of power cut and sudden shut off of the
power, our monitor keep previous setup
stage.
• [TALLY] Lamp
- Tally lamp that can be toggled in green or red
using the REMOTE(RJ-45) port or RS-422 serial
communication.
• [APERTURE] Knob
- Used to adjust the picture sharpness.
- The value is selectable between -12 ~ 12.
• [BRIGHT] Knob
- Used to adjust the degree of brightness.
- The value is selectable between -100 ~ 100.
• [CHROMA] Knob
- Used to adjust the saturation of the image.
- The value is selectable between -50 ~ 50.
• [CONTRAST] Knob
- Used to adjust the contrast.
- The value is selectable between -100 ~ 100.
• [VOLUME] Knob
- Used to adjust the volume for internal speaker
and external output.
- The value is selectable between 0 ~ 30.