TVLogic LVM-173W-3G - Manual (Page 42)

Multi F
orma
t L
CD M
onit
or
42
Multi F
orma
t L
CD M
onit
or
42
Other Functions
[2] SCAN BUTTON
◦ This product supports various scan modes.
◦ Press [SCAN] button on the front of the monitor to activate different scan modes.
1. Press [SCAN] button continuously to activate various scan modes:
OVER SCAN -> ZERO SCAN -> UNDER SCAN -> 2:1 SCAN -> 1:1 SCAN -> FIT WIDTH -> ZOOM(PBP
16:9mode)
2. Scan mode types are differed by connected signal.
- SDI, COMPONENT, RGB, DVI ANALOG, COMPOSITE 1/2/3 and S-VIDEO :
OVER SCAN -> ZERO SCAN -> UNDER SCAN -> 2:1 SCAN -> 1:1 SCAN -> FIT WIDTH -> USER SCAN ->
ZOOM(PBP 16:9mode)
- DVI DIGITAL, HDMI :
OVER SCAN -> ZERO SCAN -> UNDER SCAN -> 2:1 SCAN -> 1:1 SCAN -> USER ASPECT -> ZOOM
(PBP 16:9mode)
3. The following represents the different types of scan mode. When a scan mode is selected, display
skips the next mode if its required condition is not met.
- OVER SCAN : Zooms in/out of the image to 96% of its original size without changing the aspect
ratio of.
- ZERO SCAN : Zooms in/out of the image without changing the aspect ratio.
-UNDER SCAN : Zooms in/out of the image without changing the aspect ratio. Also, displays the
data at the top of the horizontal blanking block.
- 2:1 SCAN : Magnifies the original image two times. This feature is available only when the size of
the original image is ½ size or smaller than the screen size.
- 1:1 SCAN : 1:1 pixel mapping of original image. This feature is available only when the size of the
original image is bigger than the screen size. Press [ENTER] button to rotate the position.
CENTER -> MID LEFT -> TOP LEFT -> TOP MID -> TOP RIGHT -> MID RIGHT -> BOT RIGHT -> BOT MID
-> BOT LEFT
- FIT WIDTH : In SD mode, zooms in to fit width of the original image to the width of the screen
without changing the aspect ratio.
- USER ASPECT : Displays in user aspect ratio of HORIZONTAL and VERTICAL value that is selected
under USER ASPECT item in [PICTURE] MENU.
- 3 X ZOOM : This feature is only available under PBP 16:9 mode and displays the image with 3 x zoom in.
When "3 X ZOOM" message window appears, press [ENTER] button to activate vertical position
control of image. Use [UP]/[DOWN] button to adjust the vertical position of image. Press [ENTER]
button again to activate horizontal position control of image. Use [UP]/[DOWN] button to adjust
the horizontal position of image.