ZVOX Audio SoundBase® V Series 220 - Manual

ZVOX SoundBase
®
220/320/420 Quick Setup
“TV base” position
Shelf position
Place the SoundBase system on
a stable, flat surface. Ensure all
components are safe and secure.
Select analog input 1 (appears as “In 1” on the display)
using the INPUT button on the ZVOX remote control
OR the front panel.
Connect the DC plug of the power
supply to the DC IN jack on the back
of the SoundBase system. Put the
Power switch to OFF. Connect the
AC cord to the socket on the power
supply, then plug the AC cord into an
AC power receptacle.
Flip on the Power.
Connect to the Analog
Audio Output of TV.
Connect to the
Audio Input of
SoundBase system. Select the correct input.
Back of TV
Optical
digital input
Analog
Input 1
Analog Input
(front panel)
Connect one end of analog signal cable
to the TV’s Audio Out. A stereo miniplug
is shown. The analog Audio Out may
be Left/Right RCA phono jacks (see “a”
below).
Connect the other end of
the signal cable to Analog
Input 1 on the back panel
of the SoundBase system.
RCA Phono Jacks Analog
Audio Output
Coaxial Digital Audio Output
An orange coaxial digital audio output
jack can be used with a “PCM”
digital audio signal. See Setup guide
information about digital signals.
An RCA plug to RCA plug cable can
be used.
Optical Digital Audio Out
Postion SoundBase system. Make the power connection.
Back of TV
Back of
ZVOX system
Back of
ZVOX system Back of TV
On some TVs, the optical digital
audio output can be used. A
“PCM” digital signal is necessary.
Not all TVs provide this option.
See User Guide for information
about a “PCM” digital signal.
White/red pair of RCA output jacks
(not “input”) on the back of the TV.
MUTE VOLUME INPUT MUTE VOLUME INPUT MUTE VOLUME INPUT MUTE VOLUME INPUT MUTE VOLUME INPUT
Other Audio Connection Options
Input 1
INPUT POWER
Back of ZVOX system
OFF
AC Power Receptacle
ON
Back of ZVOX system
Back of TV
Coaxial
digital input
Analog
Input 2
Input 1
Back of
ZVOX system
The page describes connecting your SoundBase
220, 320 and 420 system to an analog audio signal
output on a TV. This is the correct audio output type
for most brands of TV. A digital audio output on a TV
may not supply a PCM format signal, the required
digital audio format by these three ZVOX models.
The Connections Guide on the opposite side of this sheet identifies the Audio
Output used for most brands of TVs. If you have any questions about connecting
your ZVOX system to your TV, please email us at i[email protected] or call our
toll-free number (866) 367-9869. Please provide your TV brand and model number.
A ZVOX Audio representative should be available Monday through Friday 9:30 AM to
7:30 PM and noon to 4:00 PM on Saturday.