Adtec digital DPI-1200 (version 01.04.08U) Manual User Manual
Page 32
1200 can be used as an NTP server if an NTP network is not available. Please refer to the
NTP Menu options under the System Menu description in Chapter 3 and additional time
configurations later in this chapter.
To configure the DM CherryPicker to time sync from the DPI-1200, select Configure from
the DM Network CherryPicker Desktop menu bar.
Select the Controller from the configuration tree. The controller information displays on the right
side of the screen along with the NTP Configuration options. (illustrated figure below)
Note: NTP sync may take up to 30 minutes to be effective
Configuring the splicer for ad grooming
Note: Terayon does not support ad insertion on loopback input modules. (source DM
Network CherryPicker 4.0 User Guide 2004)
Physical Connections
ASI - Connection of the DPI-1200 Ad Server will need to occur on one of the four inputs of
a DVB-ASI Input Module on the back of the CherryPicker using a coaxial cable with BNC
connectors. See illustration below:
Back Labeling diagram of port / slot configuration: