Amina iQP 1 - Manual (Page 2)

iQP 1/2/3
These protection units have been designed specifically to enhance the reliability of
your iQ Developer Series loudspeaker. They feature a high pass filter and a current sensing
fuse to protect the loudspeaker from being over-driven and potentially damaged. If the
protection unit senses excessive drive current from your amplifier, it will automatically
reduce the sound level from the speaker until the amplifier volume is reduced to a safe
level.
Please read this document carefully before operating your
loudspeaker and protection unit.
Ensure that the correct model iQP is used with the loudspeaker. Failure to do so may
result in speaker damage. See the label on the underside of the iQP for model
designation (see next page).
NEVER connect more than one loudspeaker to each output channel.
Be sure that all connections are made in accordance with this guide.
It is not recommended you use amplifiers with power outputs greater than the peak
power rating of the loudspeaker.
Do not intentionally cause the iQP to go into protection mode by deliberately
over-driving the loudspeaker.
If your iQP automatically reduces the audio volume from the loudspeaker frequently, it
may suggest the amplifier is too powerful or the layer of plaster applied to the iQ Developer
Series loudspeaker is too thick. In either case please consult with your dealer or Amina
Technologies Ltd.
Install this product in a cool, dry and clean place - away from direct sunlight, heat
sources, vibration, dust and moisture.
Do not expose this unit to sudden temperature changes or locate it in an environment
with high humidity. This is to prevent condensation forming inside which may cause
damage to the unit and possibly other devices connected to it.
Do not clean this unit with chemical solvents as this may damage the finish. Use a
clean, dry or damp cloth.
>
>
>
>
>
>
>
>
>
IMPORTANT: