Amina ALF40 - Manual (Page 4)

Using the Adjustable Port System
02
The ALF40 features a unique port system allowing for greater flexibility when positioning and
concealing the product.
There are two optional positions where the port can be connected to the ALF40 cabinet. An aluminium
plate (port plate) and a rubber o-ring provide an air tight seal around the port. A similar blanking plate
is used to cover and seal the unused port hole.
To remove the port and blanking plates use a number 3 Hex screwdriver to remove the four fixing
screws. Then remove the plate from the cabinet taking care not to drop the o-ring through the port
openings.
When adjusting the port length, remove the screws along with the port plate and pull/push the port by
gripping the inside surface. Ensure the o-ring is correctly positioned in its rebate before re-securing the
port plate and make sure the port is absolutely firm. If it appears loose, check the o-ring has not
dropped through the opening.
Top Position
This port position can be useful if you need to stand the ALF40 on its end (connection terminal facing
upward).
MAX 80mm