Amina iQ Developer Series - Manual (Page 15)

12
Solid wall installation with Backbox
continued...
05 Secure the speaker
Ensure the speaker cable is laid behind the
mineral wool and cannot rest against the
speaker itself.
Remove the backing paper from the six
adhesive pads on the backboxSW
mounting tabs, carefully position the
speaker onto the support tabs and apply
moderate pressure.
There should be an equal perimeter gap
between the backbox and the edge of
the speaker.
Use the flange head screws (supplied with
the backboxSW) to fix the corners of the
speaker to the four corner support tabs.
If the correct steps are taken to align the
backboxSW with the front face of the
render, the loudspeaker, when screwed in
place, will also sit flush with the front face
of the render.
Do not adjust the screws in any way, make
sure they are tightly screwed in place and
the whole assembly is firm.
Continue on to Section C
(page 18 - testing)
Reference page for correct retrofit alignment and plastering method: 13, 14 + 15
Mineral
wool
A3