Aplex Technology APC-3218 - Manual (Page 98)

APC-3X18 User Manual 98
Multiple Monitors
Multiple Monitors supports from two to six touch screen displays for one system.
The PenMount drivers for Windows 2000/XP support Multiple Monitors. This
function supports from two to six touch screen displays for one system. Each
monitor requires its own PenMount touch screen control board, either installed
inside the display or in a central unit. The PenMount control boards must be
connected to the computer COM ports via the RS-232 interface. Driver installation
procedures are the same as for a single monitor. Multiple Monitors supports the
following modes:
Windows Extend Monitor Function
Matrox DualHead Multi-Screen Function
nVidia nView Function
NOTE: The Multiple Monitors function is for use with multiple displays only. Do not
use this function if you have only one touch screen display. Please note once you
turn on this function the Rotating function is disabled.
Enable the multiple display function as follows:
1. Check the “Multiple Monitor Support” box; then click “Map Touch Screens” to
assign touch controllers to displays.