Argox AS Series - Manual (Page 15)

10
Programming the ArgoScan
8110/8120/8150/8250/8310/8312
To program the 8110/8120/8150/8250/8310/8312, you must
scan a series of programming barcode in the correct order.
Fold out the back cover of this manual. You will see a table of
alphanumeric barcodes, which are used to program the
various options presented.
To program each option, you must:
1. Scan the Program barcode on the parameter setting part.
2. Enter the option mode by scanning the Option Bar Code
(also on the Parameter setting part).
3. To the right of the option barcode, the necessary
alphanumeric inputs are listed. Scan these alphanumeric
entries from the back fold out page. To confirm above
steps, you must scan the Finish barcode on the back fold
out page.
4. Once you have finished programming. Scan the Exit
barcode, listed on the lower right hand corner of each
parameter setting part.