Artel DLC410 - Manual (Page 2)

www.artel.com | 978-263-5775 | [email protected] | [email protected]
DVB-ASI and SD-SDI Video-Over-IP Gateway
[DLC410]
DLC410 Front Panel LEDs
LED Function Color Description
OK
DLC410
Module
Status
OFF No power or power fault
n Green No alarm
n Yellow Minor alarm
n Red Major alarm
SDI
Operating
Mode
OFF ASI Mode
n Green SDI Mode
TX
Transmitter
Status (A, B)
n Green Normal operation
n Red SFP TX failure exists
 Red No SFP is installed
RX
Receiver
Status (A, B)
n Green Normal operation
 Yellow Optical Rx power too high
 Red A low receive power condition exists
ACT
Ethernet
Activity
n Green Link present
 Green Link activity
IN A,
IN B
TX
Channel
Status
OFF Channel is disabled
n Green Video is received
n Yellow No signal detected
n Red Improper video input
 Red DVB-ASI rate limited
OUT A,
OUT B
RX
Channel
Status
OFF Channel is disabled
n Green Video is received
 Green Successful FEC
 Green |  Red Unsuccessful FEC
n Yellow Provisioned but not receiving IP packets
n Red Improper video input
CHANNEL
SELECT
MON
Switch
Monitor Video Channel On
SMB Connector
Pressing Monitor Switch indicates which video channel (IN A, B or OUT A, B)
is output on MON SMB Connector. Pressing Monitor Switch while LEDs are
flashing will advance monitor output to next video channel
 Flashing green |  Flashing red
Install SFPs
AR208-008410-D00_C