Artel DLC510 - Manual (Page 2)

www.artel.com | 978-263-5775 | [email protected] | [email protected]
DLC510 Rear Panel LEDs
LED Function Color Description
OK
Module
Status
OFF No power or if power is applied to the system, an internal fault with the DLC510 may exist.
n Green Normal operation.
n Yellow Minor alarm.
n Red Major alarm.
RF A,B
RF Channel
Status
OFF Channel off.
n Green Channel on, carrier locked, demodulator locked.
n Red Channel on, carrier not locked 1 .
 Red Channel on, demodulator not locked 2 .
LNB PWR
A,B
LNB Power Status
OFF Power off.
n Green Power on.
n Red Current overload.
ASI A,B
ASI Channel
Status
OFF Channel off.
n Green ASI locked.
n Red ASI unlocked.
 Flashing red
1 Carrier not locked: The DLC510 channel is configured for a specific carrier frequency, but the carrier is too weak or not found.
2 Demodulator not locked: The DLC510 channel is configured for a specific carrier frequency, the carrier is found, but the DLC510 is unable to demodulate the signal.
Other Notes:
1. If all LEDs are off, the card is unpowered or unprogrammed and is considered defective.
2. If a channel is enabled and the carrier is not locked, RF and ASI LEDs will be red.
3. If ASI is unlocked, there will not be a valid ASI output.
Dual-Port L-Band Demodulator [DLC510]
AR208-008510-00_A