Artesyn NITX-300-ET-DVI Installation and Use (August 2014) User Manual
Nitx-300-et-dvi
Advertising
Table of contents
Document Outline
- NITX-300-ET-DVI
- Contents
- About this Manual
- Introduction
- Hardware Preparation and Installation
- Controls, LEDs, and Connectors
- 3.1 Board Layout
- 3.2 Connectors and Switches
- 3.2.1 LVDS Header (P28)
- 3.2.2 LVDS Backlight Header (P23)
- 3.2.3 LVDS Power Header (P5)
- 3.2.4 USB client header (P18)
- 3.2.5 USB Header (P6)
- 3.2.6 eUSB Header (P2)
- 3.2.7 Audio Header (P12)
- 3.2.8 CAN Bus Header (P15)
- 3.2.9 Full Wire RS232 Header (P7)
- 3.2.10 Two Wire RS232 Header (P14)
- 3.2.11 Battery Socket (XBT1)
- 3.2.12 Front Panel Header (P19)
- 3.2.13 GPIO Header (P4)
- 3.2.14 CPU FAN Header (P1)
- 3.2.15 SATA Power Header (P16)
- 3.2.16 J9 SATA Connector
- 3.3 Onboard LEDs
- Functional Description
- 4.1 Block Diagram
- 4.2 Processor
- 4.3 System Memory
- 4.4 PCI-E Port
- 4.5 SATA
- 4.6 MicroSD
- 4.7 Ethernet Interfaces
- 4.8 USB Interface
- 4.9 USB Flash
- 4.10 RS-232
- 4.11 CAN bus
- 4.12 I2C Serial Interface and Devices
- 4.13 Video Interface
- 4.14 Audio Interface
- 4.15 BIOS Device
- 4.16 GPIO Configuration
- 4.17 Clock Distribution
- BIOS
- Operating System and Driver Support
- A Replacing the Battery
- B Related Documentation
- Safety Notes
- Sicherheitshinweise