Dolby Laboratories SDV-27 - Manual (Page 16)

16
Remote control unit and main unit preparations
Notes on using the remote control unit
ƒ Do not drop or step on the remote control unit or subject it to shocks, as this may damage it.
ƒ Note that the remote control unit may not work if there are obstacles between it and the remote
sensor.
ƒ Do not expose the remote sensor to strong light. Doing so may make operation impossible.
ƒ Use the remote control unit within the specified operating range.
Replacing the battery
1 Insert your finger nail into A and B on the diagram
below, press A according to the direction, then pull
out the battery holder.
2 Remove the old battery, then insert the new battery
into the battery holder with the + side facing
upwards.
3 Fit the battery holder back into place.
Note:
To prevent leakage of fluid from the lithium battery, remove the battery when not using the remote
control unit for long periods of time (one month or more). If the battery leaks fluid, carefully wipe it out of
the battery case, then change to a new lithium battery.