Avalon Firestyles 564 SS Stainless Steel Fireback - Manual (Page 2)

564 SS Stainless Steel Fireback Installation
SKU # 96100180
Page 2 of 2 7/25/07 Travis Industries, Inc.
3 Install the firebacks following the directions below
Place the rear fireback in place. The side
fireback holds the rear fireback in place -
hold the rear fireback while installing the
side fireback.
Remove the clip and screw located on the
firebox ceiling near the front (both sides).
Place the side
firebacks in place.
a
1/4" Nutdriver
c
Replace the clips and screws
removed in step “a” to secure
the side firebacks..
e
d
b
Place the floor fireback in place. Replace
the screw and bracket.
COLORATION AND CLEANING: These stainless steel firebacks will obtain a slight
“patina” (brown tint) after use. Do not clean the firebacks. This patina becomes
consistent. Any cleaning may lead to unequal coloring. If soot forms on the fireback,
we recommend brushing it off with a soft cloth or brush.
4 Restore the fireplace to the correct configuration.