Avalon Firestyles 564 HO DiamondFyre Burner User Manual
Page 2
564 HO DiamondFyre Burner
Installation Instructions
(sku: 96900115)
Page 2 of 6
17601656 — 8/21/13
© Travis Industries, Inc.
Burner Installation
1. Remove both accent light assemblies from the brackets at the rear of the firebox (discard the screws).
Remove and discard the front light cover from both assemblies. See Figure 2 below.
Place the accent light assemblies in the center of the firebox floor, as shown below.
NOTE: Do not touch the bulbs.
Figure 1: Accent light bracket screws location
Figure 2: Remove front light cover
Figure 3: Accent lights placed on firebox floor
2. Install the intake restrictor as shown below, using the existing screws on the rear wall of the firebox.
Set the intake restrictor to the correct setting for the vent configuration. See the installation manual for
details.
Figure 4: Intake restrictor installed, showing location of screws