Avalon Firestyles High-Temperature Wood Insert Wiring Kit - Manual

High-Temperature Wood Insert Wiring Kit
97200337
Page 1 of 6 1/31/14 - 17601776 © Travis Industries, Inc.
Overview
The high-temperature wood insert wiring kit allows an installer to conceal the power cord from the blower
behind the surround panel for the Travis products listed below. The wire harness is routed through the
convection channel from the right side and attached to the blower.
Compatibility
• Lopi Revere (SKU 99800303 – cast ashlip)
• Lopi Freedom (SKU 99800153 – cast ashlip)
• 1750 Insert (SN 1112-003324 or greater)
• 1250 Insert (SN 1111-001903 or greater)
• Flush Wood Inserts (Small, Medium, Large)
Packing List
• Wire Harness (10’ Length) with Mounting Plate
• 10-24 x ½” Thread-Cutting Screw
• Button Plug
This kit must be installed in accordance with local electrical codes. Consult your local building
official for any requirements that must be met in your area.
Make sure the electrical lead leading to the insert has been disabled prior to installing this kit.
Installation – Revere, Freedom, 1750, 1250
1 Use pliers to disconnect the strain relief from the front blower. Discard the strain relief.
2 Disconnect the power cord from the blower. Route the power cord out of the blower housing and discard.