Avery Dennison FreshMarx 9415 Operator Handbook - Manual (Page 11)

L o a d i n g L a b e l s
1. Dual printer: Printer 1 is located on the left and
Printer 2 is located on the right. Printer 1 is the
default printer for all categories and formats.
2. Single printer: Printer 1 (located on the left) is
the only available printer. There is no option to
assign a format to a printer.
3. The first time you load the printer after receiving it
you must remove and discard the thermal paper
from the printer slots.
4. Turn on the printer. Press the power switch on the
side of the printer to the on (I) position.
5. Press to remove the thermal paper from the
printer, if necessary.
6. Remove and discard the tape from a new roll of
labels.
7. Lower the supply door.
8. Slide a roll of labels onto the supply holder.
If necessary, adjust the supply holder guide so it
touches the roll.
9. Feed the labels, printing side up, into the supply
slots in the supply door.
Note: Make sure no label adhesive is exposed when
loading labels. This causes jams.
Getting Started 1-5