Avery Dennison FreshMarx 9417 Replacing the Printhead - Manual

R E P L A C I N G T H E P R I N T H E A D
Use these instructions to replace the printhead assembly in the 9417 Printer.
A u d i e n c e
These instructions are intended for a skilled service technician only. For additional information or
assistance, call Service at 1-800-543-6650.
C a u t i o n s
 The 9417 printer contains devices that are sensitive to electrostatic discharge (ESD); failure to
exercise caution can damage the printer. We recommend using an ESD wrist strap, grounding
mat, or grounding workbench when performing maintenance on the printer.
 Flex connectors between components and board assemblies are extremely fragile; when
damaged, they require component or board assembly replacement.
R e q u i r e d T o o l s
The procedures require the following:
 A hard, dry surface to set the printer on
 Phillips screwdriver
 Tape (can be clear adhesive tape, black electrical tape)
Avery Dennison® is a registered trademark of Avery Dennison Corporation. ©2013 Avery Dennison Corp. All Rights Reserved.
TC9417PHI Rev. AA 8/13