Avery Dennison 1115 Monarch - Manual

®
Monarch
®
1115 ® Labeler
Operating Instructions
TC1115OI Rev. BE 12/07 ©2006 Paxar Americas, Inc.
a subsidiary of Avery Dennison Corp. All rights reserved.
LOADING LABELS & SETTING PRINT BANDS
LOADING LABELS
1 Slide label roll between hubs.
Discard first fourteen labels
and backing paper.
2 Squeeze operating lever and feed
label strip over spring and under brake
wheels until about twelve labels come out.
3 Feed label strip up under plate until
two labels come out. Rewind
label roll until loop is removed.
4 Pull backing paper to the end of the
operating lever, separating labels from
backing paper.
5 Tear backing paper evenly
between cuts, close to the end of the
strip as shown.
6 Hold labeler upside down and while
squeezing operating lever, feed
backing paper into slot. Squeeze operating
lever eight times until backing paper comes
through the rear exit.
7 If backing paper does not become
taut and exit at rear: Turn labeler
upside down, squeeze operating lever and
pull backing paper out of slot. Repeat
steps, 4, 5, and 6.
SETTING PRINT BANDS
1 Pull the knob until the
indicators point to
the desired band.
4 Print a sample label to insure
information is correct.
2 Turn the knob untill the indicators
point to desired character or blank. 5 If the character prints UPSIDE
DOWN, turn the band until you can
read the characters correctly. The desired
character may be coated with ink.
3 Set all bands and push the knob
in all the way.
INKING
1 Move two latch buttons toward
label roll and swing top cover
away from print head.
2 Fold a piece of scrap backing
paper.
3 Insert folded backing paper
between ink roll and carrier.
Pull to snap old ink roll free.
4 Cut off end of ink roll package.
Using package to protect fingers,
slide carrier into package and snap new ink roll
into carrier.
5 Snap top cover closed.
Hang for easy reference.
Brake
Wheels
Label Exit
Operating
Lever
Label Exit
Loop
Plate
Hub
Backing
Paper Discarded
Labels
Slot
Backing
Paper Exit
Knob
Indicator
Blank Print
Positions
Top Cover
Latch
Button
INKING
Cap
End
Carrier