Avery Dennison 6037 Read This First - Manual

2. Press the latch buttons and open the supply cover.
Loading for Peel Mode
3. Open the spring-loaded supply holder and place the
supply roll in the supply holder so that the supply
feeds from the bottom.
4. Peel and discard the first four inches of labels from
the backing paper.
5. Hold the printer upright and gently press down on
the label deflector. (It may be stiff.)
6.
over
under
Feed all four inches of the backing paper
the peel
bar and the label deflector.
under the applicator roller,
7. Push the label deflector up until it snaps
into place.
8. Partially close the cover to the first
position.
9. over Pull the backing paper the guide
rollers, down to the pinch and feed rollers.
10. Hold the backing paper edge between the
feed and pinch rollers, and press the
trigger.
11. Close the cover and press ESC to exit.
Cover
Supply Holder
Applicator
Roller
Label Deflector
Peel Bar
Pinch Roller
Feed Roller
(behind pinch roller)
Roller Guide
(behind supply)
1.
6032:
6037:
Turn on the printer and put into load mode.
Press Load key.
Press Function and 0 (zero.)
Or, ask your System Administrator.
See the for more
information. An 18” X 24” Wall Chart
(TC603XWC) is also available. Contact your
Sales Representative for more information.
Equipment Manual
Read This First!
Latch Buttons
TC603XPEELQR Rev. AA 3/03 ©2003 Paxar Americas, Inc. All rights reserved.
Label Deflector