Avery Dennison 9414 Equipment Manual - Manual (Page 23)

L o a d i n g F a n - F o l d S u p p l i e s
1. Place a stack of fan-fold supplies behind to the
printer, label side up.
You may have to move the printer
to allow room for the supply.
2. Press the cover release buttons (on both sides of
the printer) towards the front of the printer. Lift
open the cover.
3. If necessary, remove any supply that has been
previously loaded by pushing out on the supply
holder tabs. The supply should lift out of the printer.
4. Adjust the supply guides to their widest position by
turning the dial.
5. Open the supply holders to their widest position by
pushing out the supply holder tabs.
6. Hold open the supply holders while tightening screw.
Screw
Loading Supplies 2-11