Avery Dennison 9850 Addendum Version 3.5 - Manual

TC9850AD3 Rev. AA 9/02

2002 Paxar Corporation. All rights reserved.
O P E R A T O R ' S A D D E N D U M
This addendum describes the software changes available in release 3.5 of the
PAXAR

Monarch

9850

printer. This addendum contains information about the
revised and new menu selections, updated programming information, and updated
error messages.
S e t t i n g t h e D i s p e n s e P o s i t i o n
1. From the Main menu, select Setup, then Supply. Press l or r until you see
SUPPLY
l Positioning r
2. Press Enter/Pause. Press l or r until you see
POSITIONING
l Dispense Pos r
3. Press Enter/Pause.
Dispense Pos
[50/200]: +65
4. Press l or r to change the dispense position. The dispense position adjusts
the stopping point of the label. Pressing l decreases the value; r increases
it.
Feed/Cut acts as a toggle switch to change the value by 10 or 1. For example,
to make the dispense position 90 (from the default 65), press Feed/Cut, then
press r twice (85), press Feed/Cut again and press r five times (90). Press
Enter/Pause to select the displayed value.
5. Press Escape/Clear until you see the Main menu.
S e t t i n g t h e B a c k f e e d D i s t a n c e
1. From the Main menu, select Setup, then Supply. Press l or r until you see
SUPPLY
l Positioning r