Avionics Innovations AI-CD II P/N: 14001-20 Installation Manual User Manual
Page 7
Avionics Innovations
AICD II Installation Manual
INSTALLATION INSTRUCTIONS
NOTE
FOR TECHNICAL ASSISTANCE PLEASE CALL 760-788-2602 8:00 AM TO 5:00 PM PST.
ALL REPAIRS AND RETURNS ARE PROCESSED THROUGH AVIONICS INNOVATIONS
1.
Select an appropriate location in the instrument panel for the AICD II tray. The AICD II must be mounted
horizontal (75 to 90 degrees)
A. Location should be as near to center to maximize viewing quality.
2. Mount tray in location using 4 6/32 countersunk screws. Screws must mount flush to the
inside of the tray for clearence.
3. Wire the unit as per diagram.
4. Install antenna on bottom or top of aircraft using approved practices and
data.
5.
Use RG 142 for antenna lead.
INSTALLATION NOTES:
1.
In some installations the radio reception may be poor on the ground. This is normal, an in-flight operational
check should be accomplished after installation to ensure proper radio reception.
2.
*** ( 14 volt systems ) low batteries may hinder operation prior to engine start
3.
Consult the intercom manufacturer for specifications and hookup instructions.
4.
On mono installations refer to the installation schematic for proper installation.
5.
Unit must be completely seated in tray to ensure proper connection.
6. Do not over tighten the unit into the tray. Over tightening can damage unit.
7. Compact disc’s with scratches or other markings will cause skipping
POST INSTALLATION CHECKOUT
1.
Ensure unit operates according to the AICD II operation manual 14000-30
NOTE
This unit is equiped with a clock funtion, but due to the different voltage environments this unit
serves, it cannot be relied on as a time keeping device. Please ensure owner is briefed on this note.
Revision NC 6/8/99
Page 6