Avionics Innovations DVD/AM/FM Receiver P/N: AV2007 Installation Manual - Manual (Page 7)

INSTALLATION INSTRUCTIONS
Pre-Installation
Always follow proper avionics installation practices per FAA Advisory Circulars (AC) 43.13-1B or later
FAA approved revision of this document.
Installation
1. Select an appropriate mounting location for the AI-DVD. Consider accesability to
service loops for cables and wire runs.
2. Mount the AI-DVD using (4) AN525-832 bolts, length TBD, (4) MS21044N08 self
locking nuts and supplied brackets. Refer to drawing AV2030 (Attached at the rear of
this manual).
3. Wire unit per drawing AV2028 (Attached at the rear of this manual).
4.
This unit requires an external antenna for the AM/FM Receiver. Comant Industries CI-222 is
recommended. Ensure the antenna meets requirements of installation. Refer to manufactures
specifications.
5. Power and Ground wiring should be 20 AWG.
6. Audio wiring should be 22 AWG.
7. Antenna Coax should be RG142 or equivalent.
8. Video Coax should be RG59 or equivalent.
Post Installation
1. Ensure unit operates in accordance with operation manual.
2. Test and ensure that the unit does not interfere with any other systems on the aircraft.
Revision NC 11/01/2001
Page 6
Avionics Innovations, Inc.
AI-DVD Installation Manual