BAFO BF-5320 - Manual (Page 4)

2.4.Update driver on Windows NT 4.0
1. After OS boots up, click 'Start'.
2. Under 'Settings', click 'Control Panel'.
3. Select 'SCSI Adapters' from the Control Panel.
4. Select the 'Drivers' tab and click 'Add'.
5. Click 'Have Disk'.
6. Insert the Driver CD into D: and press 'Enter'.
7. Choose 'Silicon Image SiI 3112 SATALink Controller' and click 'OK'.
8. Refer to instructions in section 4 to verify controller was installed correctly.
2.5.Update driver on Windows 2000
With the Serial ATA 2 Port CardBus already plugged in and the driver already installed.
Follow the instructions below to update SiI 3112 SATALink driver.
1. Right click on 'My Computer' and select 'Properties'. Under the 'System
Properties' section, click on 'Hardware' tab, and then on 'Device Manager' click
'SCSI and RAID Controllers' and right click 'Silicon Image SiI 3112 SATALink
Controller' then select 'Properties' from the context menu.
2. Click 'Update Driver' button on the 'Driver' tab and select 'Display a list of the
known drivers for this device so that I can choose a specific driver'. Insert
the Driver CD into the CD-ROM drive. Click 'Next'.
3. Click 'Have Disk'. On the 'Install from Disk' dialog ensure that the correct
floppy drive is specified and click 'OK'.
4. Click 'Next' until the installation process begins. If presented with a dialog
warning about an unsigned driver click 'Yes' to accept it.
5. If at the end of the installation process you are prompted to reboot the system
click 'Yes'.
6. See instructions in section 4 to verify controller was installed correctly.
2.6.Update driver on Windows XP
Follow the instructions in this section to update the driver for the SiI 3112 SATALink
controller on Windows XP.
1. Right click on 'My Computer' and select 'Properties'. Under the 'System
Properties' section, click on 'Hardware' tab, and then on 'Device Manager' click
'SCSI and RAID Controllers' and right click 'Silicon Image SiI 3112 SATALink
Controller' then select 'Properties' from the context menu.