BAFO BF-812 User Manual
Page 7
USB to Serial Adapter User’s Manual 7
9
8
9
8
9
8
9
8
If you can successful install the driver but cannot use the USB-Serial Adapter with
connect the other device:
Go to the
Control Panel-System-Device Manager and check the COM
(COM&LPT),
if you cannot see this item:
11.1 Please check the
BIOS setting I/O configure setting Onboard
serial port 1
, choose the setting is enabled and choose the value. Then
return to the windows and check it again.
11.2 Go to the
Control Panel Add New Hardware
, following the step and
choose the hardware from the list, select the
Ports(COM&LPT
) and
following the step to install the driver that is needed.
(In this process you
may need to put the WINDOWS CD into the CD-ROM drive.)
1 $
'
1 $
'
1 $
'
1 $
'
Information in this document is subject to change without notice. The manufacturer
does not make any representations or warranties (implied or otherwise) regarding
the accuracy and completeness of this document and shall in no event be liable for
any loss of profit or any other commercial damage, including but not limited to
special, incidental, consequential, or other damages.
No part of this document may be reproduced or transmitted in any form by any
means, electronic or mechanical, including photocopying, recording or information
recording and retrieval systems without the express written permission of the
manufacturer.
All brand names and product names used in this document are trademarks, or registered
trademarks of their respective holders.
"
"
"
"
#!!
'
#!!
'
#!!
'
#!!
'
This device generates and uses radio frequency and may cause interference to radio
and television reception if not installed and used properly. This has been tested and
found to comply with the limits of a Class B computing device in accordance with the
specifications in Part 15 of FCC Rules. These specifications are designed to provide
reasonable protection against such interference in a residential installation. However,
there is no guarantee that interference will not occur in a particular installation. If this
device does cause harmful interference to radio or television reception, which can be
determined by plugging the device in and out, the user can to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the device and receiver.
Connect the computer into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help