Baumatic WD02SS - Manual (Page 15)

steel wool pads) or sponges that contain a residual abrasive
detergent.
o The anti-slip warming drawer bottom can be cleaned if you are
thoroughly cleaning the appliance. It can be hand-washed with
warm water and a mild detergent. The bottom should be dried
thoroughly afterwards and not placed back into the appliance
until it is completely dry.
o Any damage that is caused to the appliance by a cleaning
product will not be fixed by Baumatic free of charge, even
if the appliance is within the guarantee period.
INSTALLATION
The installation must be carried out by a suitably
qualified person, in accordance with the current
version of the following.
o UK Regulations and Safety Standards or their European Norm
Replacements.
o Building Regulations (issued by the Department of the
Environment).
o Building Standards (issued by the Scottish Development
Department).
o IEE Wiring Regulations.
o Electricity At Work Regulations.
Before connecting the appliance, make sure that the supply voltage
marked on the Rating Plate corresponds with your mains supply
voltage.
WARNING: THIS APPLIANCE MUST BE EARTHED.
o This appliance should be wired into a 13 A double pole switched
fused spur outlet, having 3 mm contact separation and placed in
an easily accessible position adjacent to the appliance. The spur
outlet must still be accessible even when your warming drawer is
located in its housing.
o To connect the power cord, loosen and remove the cover on the
terminal block, in order to gain access to the contacts inside.
Make the connection, securing the cord in place with the cable
clamp provided and then immediately close the terminal block
cover again.
15