BDI 2201 Marina - Manual (Page 3)

assembly instructions
bdiusa . com customerservice @ bdiusa . com
Component List
Designed by Cristian Wicha.
‘Marina’ is a trademark of Becker Designed, Inc.
All rights reserved. ©2009 Becker Designed, Inc.
Made in China. 2210REV102609v2
M
a r i n a
2210
a s s e m b l y i n s t r u c t i o n s
bdiusa
.
com customerservice
@
bdiusa
.
com
Your Marina Furniture is engineered for easy assembly. Carefully follow
this procedure to prevent any damage.
Placement and Maintenance
Marina Furniture is designed for indoor use on level floors. Clean glass with
glass cleaner, and steel parts and wood veneer with a moist cloth.
Step 1
Unpack and identify the parts listed. The assembly workspace should be a
non-marring surface such as carpet. For missing hardware pieces please
contact BDI Customer Service at [email protected]. For all
other concerns, please contact your BDI Retailer.
Step 2
The Marina End Table can be assembled with either a HIGHER or LOWER
shelf location. Determine which orientation you prefer before completing
remaining steps.
Step 3
Thread one (1) Stud (F) into each Leg (B) at notch in leg and finger-tighten.
Step 4
Fasten each properly-oriented Leg to the
Shelf by inserting the Stud with gentle force
into each Shelf corner; then install one (1)
Crescent Plate (H) on inserted end of Stud
(F) with one (1) Nut (G).
NOTE: Round surface of Crescent Plate must
mate flush with curved cut-out area within
shelf.
Tighten each Nut (G) with supplied Wrench
(I).
Step 5
Invert Leg (B) & Shelf (C) assembly so that
the bottom of each Leg (B) is facing UP; then
thread one (1) Leveler (E) into the bottom of
each Leg.
Step 6
Invert assembly again and insert one (1)
Stem Bumper (D) into the top of each Leg.
Step 7
Carefully center and rest Glass Top (A) on
Stem Bumper (D) to complete assembly.
G - Nut x 4
F - Stud x 4
D - Stem Bumper x 4
E - Leveler x 4
H - Crescent Plate x 4
C - Shelf x 1
B - Reversible Legs
x 4
A - Glass Top x 1
I - Wrench x 1
E x 4
D x 4
G
H
F
B x 4
1