Ethernet cables, Sold by meter, Pre assembled cables – BECKHOFF CU2608 User Manual
Page 14
Mounting and cabling
10
CU2608
Ethernet cables
For connecting Ethernet devices only shielded Ethernet cables that meet the requirements of at least category 5
(CAt5) according to EN 50173 or ISO/IEC 11801 should be used.
Recommendations about cabling
Note
You may get detailed recommendations about cabling Ethernet from the documentation
"Recommendations for the design of the infrastructure for EtherCAT/Ethernet", that is
available for download at www.Beckhoff.com.
Ethernet uses 4 wires for signal transfer. Due to automatic cable detection (auto-crossing) symmetric (1:1) or cross-
over cables can be used between Ethernet devices from Beckhoff.
A selection of cables for Ethernet (her only up to 10m) follows. Other cables with various lengths will be found in the
full Beckhoff catalogue, and under www.beckhoff.com.
Sold by meter
Designation
Description
ZB9010
CAT 5e, 4-core, for fixed laying, not for M8 connectors
ZB9020
CAT 5e, 4-core, suitable for drag chain use, not for M8 connectors
ZB9030
PVC, dia. 4.9 mm for M8 connectors
ZB9031
PUR, dia. 4.8 mm for M8 connectors
ZB9032
PUR, dia. 5.4 mm for M8 connectors, high flexibility
Pre assembled cables
ZK1090-6161-0xxx: M12 plug - M12 plug, PUR, ready-assembled
ZK1090-6161-
0005
0010
0020
0025
0050
0100
Length
0.5 m
1.0 m
2.0 m
2.5 m
5.0 m
10 m