Besa Lighting Luma Slim (Flush Mount) - Manual

6695 Taylor Rd. Blacklick, OH 43004
www.besalighting.com
CEILING FIXTURE INSTALLATION GUIDE
Models using P300112 Series (Med. Base 120V)
P300112, Rev.1 5-10
Use With
these Models:
• Ring 13
(9772xx)
• Nova 10
(9772xx)
• Slipstream 11
(9038xx)
Caution: Turn off power to electrical box before installing
CAUTION-RISK OF FIRE: Min 90C SUPPLY CONDUCTORS. This fixture requires that the branch supply wires
be rated: MIN 90C. Most dwellings built before 1985 have supply wire rated 60C.
CONSULT A QUALIFIED ELECTRICIAN TO ENSURE CORRECT BRANCH CIRCUIT CONDUCTOR.
All electrical connections and the installation of this fixture must be in agreement with local codes,
ordinances or the NEC (National Electric Code) or CEC (Canadian Electrical Code).
Do not connect this fixture to an electrical system that does not provide a means for equipment grounding.
1. Carefully unpack parts. Fasten Mounting Strap (A) to Outlet box with Machine Screws (B).
2. Attach supply ground conductor to Mounting Strap with the green ground screw (C)
3. Thread the Threaded Studs (D) into the Mounting Strap as shown.
4. Connect the fixture conductors to the supply conductors with wire nut connectors (E) as shown:
White fixture wire to white supply wire and black fixture wire to black supply wire.
Carefully push wires and wire nuts back into outlet box.
5. Place the fixture Canopy (F) over the outlet box so that the Threaded Studs protrudes
through the two mounting holes in canopy.
6. Secure the Canopy to the ceiling with the Star Washers (G) and Cap Nuts (H), as shown.
Tighten the cap nuts firmly by using Pliers or 5/16” Nut Driver.
7. Insert bulb(s) of indicated type and of no greater wattage than marked on fixture.
Do not exceed wattage, as that could cause fixture to overheat.
8. To attach Glass Diffuser (I), align the open slots (J) in the glass rim with the indented dimples
on the fixture canopy. Insert glass into canopy and twist the glass clockwise until secure.
9. Restore power.
A
B
C
D
E
F
G
H
I
J