Besa Lighting Surface Power Supply (Monorail Component) - Manual (Page 2)

INSTALLATION GUIDE
Model SA60LED LED Monorail Canopy
(For use with Besa low voltage LED lighting systems only)
SA60LED, Rev.1 8-12
Caution: Turn off power to electrical box before installing
6695 Taylor Rd. Blacklick, OH 43004
www.besalighting.com
Mounting
Plate
Electrical
Supply Box
Canopy
Set Screws
1. Connect the electrical leads from the
transformer to the house supply wires,
black to black and white to white, and
secure with the wirenuts provided.
2. Loosen Canopy Set Screws to
release Mounting Plate. Push the Red
Low Voltage Transformer Wires through
the center opening in the Mounting Plate.
3. Secure Mounting Plate to the electrical
Supply Box using Machine Screws.
4. Connect the Red Low Voltage
Transformer Wires to the White Canopy
Wires, then secure with the wirenuts
provided.
5. Carefully push the wirenuts and wiring
back into the Supply Box, then position
the Canopy up to the ceiling.
6. Tighten the three (3) Set screws until
the Canopy is secure to the ceiling.
7. The monorail can now be connected
to the canopy.
NOTE:
For applications where the monorail
is not directly below the canopy,
utilize the flexible feed provided.
Installation of Canopy:
1. Loosen Set Screw on the Rail Adapter of the Canopy.
2. Raise the Monorail into the Rail Adapter, then tighten Set Screw.
3. Turn on power to system.
Operate system for 5 minutes, then verify that the connections are running cool to the touch.
Installation of Monorail:
Machine
Screws
Canopy
White
Canopy
Wires
Canopy
Monorail
Rail Adapter
The SA60LED uses a 60 watt low voltage electronic
transformer, designed to power multiple LED
luminaires with a combined load of 60 watts or less.
No minimum load is required.
For dimming, an electric low voltage
dimmer is recommended.
Transformer Operation:
Red
Low Voltage
Transformer
Wires