Besa Lighting Standoff (Monorail Component) - Manual

6695 Taylor Rd. Blacklick, OH 43004
www.besalighting.com
INSTALLATION GUIDE
Model STAN1 Rigid Standoff Support
(For use with Besa low voltage lighting systems only)
STAN1, Rev.3 2-09
Ceiling
Decorative cap
1. Select standoff location and install
the supplied anchor into ceiling.
2. Secure the Decorative Cap and
Threaded Adapter to ceiling using
the supplied Philips screw.
Anchor
Threaded Adapter
Philips Screw
INSTALL MOUNTING HARDWARE:
1. To install the Rail, loosen the Set Screw on the
Rail Adapter and lift the Rail into the opening on
the Rail Adapter. Tighten the set screw securely.
2. The rail can be repositioned by slightly loosening
the set screw on each standoff, then retightening
when finished.
Rail Adapter
Set Screw
Rail Section
SECURING THE RAIL SECTION:
Threaded
Adapter
Rail
Adapter
Rigid
Standoff
Securing Rigid Standoff to Mounting Hardware
for use with Besa Surface Transformers
(SM300 or SA300)
1. Thread the Rigid Standoff
onto the Threaded Adapter.
2. Using the hex wrench
provided, the Rail Adapter
can be adjusted by loosening
the hex screw on its side
and rotating.
3. Proceed to
SECURING THE RAIL
SECTION below.
If using a Remote Transformer with a Remote Feed-type
Canopy, or other height adjustment is needed, first follow
the instructions at right.
Hex Wrench
Short Post
Long Post
Rigid Standoff setup for use with Besa
Remote Transformers (REMFC Canopy Feed)
1. Using the supplied Hex Wrench, remove the
Long Post from the Rigid Standoff and replace
with the supplied Short Post.
2. Tighten set screws with
the supplied Allen Wrench.
The shorten Rigid Standoff
is ready to be installed.
3. Thread the Rigid Standoff
onto the Threaded Adapter.
4. Using the hex wrench provided,
the Rail Adapter can be adjusted
by loosening the hex screw on
its side and rotating.
* For applications using
an extension rod,
(Besa model number
EXT06, EXT12, or EXT18)
the rod should be installed
during this step.