Besa Lighting Flexible Cable (Monorail Component) - Manual

INSTALLATION GUIDE
Model FLX60 Flexible Feed Cable
(For use with Besa low voltage lighting systems only)
FLX60, Rev.2 2-09
6695 Taylor Rd. Blacklick, OH 43004
www.besalighting.com
Power Supply Canopy
1. Using a Hex Wrench, loosen two set screws on the
sides of the Rail Adapter located on the underside
of the Power Supply Canopy
2. Carefully remove the Rail Adapter from the Power
Supply Canopy, exposing the two Feed Posts.
Rail Adapter
Feed Posts
Rail Adapter
A) Remove the Rail Adapter:
Hex Wrench Flexible Feed
Adapter
1. Using a Hex Wrench, loosen the set screws on the
sides of the Flexible Feed Adapter, then
install the Flexible Feed Cable and tighten.
2. Shorten the Flexible Feed Cable to the desired length.
3. Insert the Flexible Feed Cable into the Rail Adapter
and the Flexible Feed Adapter onto the Feed Posts.
B) Install Flexible Feed Cable:
Flexible Feed
Cable
Flexible Feed
Adapter
Rail Adapter
1. Using a Hex Wrench, secure the Flexible Feed
Adapter to the Power Supply Canopy.
2. Using a Hex Wrench, secure the Rail Adapter to
the Flexible Power Feed.
C) Secure Flexible Feed Cable:
Rail Adapter Set Screw
Rail Section
1. Loosen Set Screw on the Rail Adapter of the Canopy.
2. Raise the Monorail into the Rail Adapter, then
tighten Set Screw.
3. Turn on power to system.
D) Installation of Monorail:
NOTE:
Operate system for 5 minutes, then verify that
the connections are running cool to the touch.
IMPORTANT SAFETY INSTRUCTIONS:
A) Read all instructions.
B) Do not conceal or extend exposed conductors through a building wall.
C) Do not install this system in wet locations.
D) For low voltage exposed insulated conductor systems required by 30.1(c) do not install
any part of this system less than 7 feet (2.2m) above the floor.
E) To reduce the risk of fire and burns, do not install this lighting system where the exposed
bare conductors can be shorted or contact any conductive materials.
F) To reduce the risk of fire and overheating, make sure all connections are tight.
G) Do not install any luminaire closer than 6 inches (15.25 cm) from any curtain, or similar combustable materials.
H) Turn off electrical power before modifying the lighting system in any way.
SAVE THESE INSTRUCTIONS