Besa Lighting Willow (Mini Pendants 12V) - Manual

QUICK CONNECT INSTALLATION GUIDE
Model XP Willow LED Series (Low Voltage LED Pendant Set 12V)
XP_Willow_LED, Rev.1 5-13
6695 Taylor Rd. Blacklick, OH 43004
www.besalighting.com
This low voltage Pendant Cord Assembly has been designed to be used with Besa Low Voltage Quick
Connect Adapters. Operate with a low voltage transformer (12V) and never wire directly to 120 volts.
1. Making a clean cut, shorten the cord to the desired length.
6. Feed the wire until it reaches the top set screw position. Confirm
by viewing the Center Conductor through the Viewing Hole.
7. The Brass Collar should align with the bottom of the
Quick Connect Jack, if not then trim the Center Conductor.
8. Tighten the top set screw first, then the lower. Do not overtighten
the set screws and make sure the set screws avoid the seam
in the Brass Collar. The pendant can now be installed onto
Quick Connect Adapter.
9. Insert the post of the Quick Connect Jack into the
Quick Connect Adapter. Thread the top half of the
conical section until it seats with the adapter.
4. Remove the exposed braiding by pulling away from
the center conductor, then cutting off excess.
Leave 1/16” of braided material or less.
2. Carefully strip off 1-3/4” of the outer jacket using
the Stripping Tool provided.
It is important not to damage the
inner silver braiding. Practice this
step on a scrap section of cord first.
1-3/4”
3. Slide the Brass Collar over the braiding.
Make sure the Brass Collar does not
damage the braiding to ensure
a good connection.
1/8”
5. Strip off 1/8” of insulation from the Center Conductor.
The exposed stranded wire of the Center Conductor
must be tightly wound before proceeding.
Gently Tighten
Using Pliers
Loosen Set Screws,
If Necessary
Orient So Set Screw
Is Not On Seam
IMPORTANT: KEEP THESE INSTRUCTIONS FOR YOUR RECORDS
All electrical connections and the installation of this fixture must be in agreement with local codes,
ordinances or the NEC (National Electric Code) or CEC (Canadian Electrical Code).
Do not connect this fixture to an electrical system that does not provide a means for equipment grounding.
All electrical connections and the installation of this fixture must be in agreement with local codes,
ordinances or the NEC (National Electric Code) or CEC (Canadian Electrical Code).
Do not connect this fixture to an electrical system that does not provide a means for equipment grounding.