Besafe X3-GB - Manual (Page 2)

2 3
!
!
Thank you for choosing BeSafe iZi Combi.
Contents
Vital information
• It is NOT ALLOWED to mount the seat in a front
passenger seat WITH AN ACTIVATED AIRBAG.
• iZi Combi can be installed rearward-facing with a
3-point car belt, approved to UN/ECE Regulation
No. 16 or other equivalent standards.
• iZi Combi can be installed forward-facing with a 3-point
car belt, approved to UN/ECE Regulation No. 16 or other
equivalent standards.
• iZi Combi is approved in groups 0+ and 1, rearward-facing
from 0-18 kg and group 1, forward-facing from 9-18 kg.
• Read the car list to find out whether your car model is
approved to use the seat.
• The harness straps must always be locked when the child is
in the seat.
• The harness straps must be tightened without slack and
not twisted.
• The seat cover contains magnets in the areas with the orange
indications. Magnets can influence electronic equipment like
pacemakers.
• The floor support must always be used when it is installed
rearward-facing. Make sure that the floor support is fully
pushed down. When installing forward-facing the floor support
and the front brace shall not be used.
• We recommend to use the seat as long as possible in the
rearward-facing installation.
• We recommend that this seat is used only for children who
can sit upright, so not younger than 6 months.
• For children under 1 year and/or under 10 kg weight, we
recommend that the most reclined sitting position and the
body hugger and seat cushion are used.
• When the child weighs over 18 kg or the shoulder height
grows above the highest position of the shoulder straps, the
child must change to a group 2/3 seat.
• After an accident, the seat must be replaced. Although it may
look undamaged, if you were to have another accident, the
seat may not be able to protect your child as well as it should.
• Prevent the seat from becoming trapped or weighed down by
luggage, seats and/or slamming doors.
• Before every use, make sure the harness is not damaged
or twisted.
• Make sure you can fit no more than one finger between the
harness and your baby (1cm).
• If in doubt, consult either the child restraint manufacturer or
the retailer.
BeSafe has developed this seat with much care, to protect your
child during the next phase of her or his life.
Vital information 2
Preparing to install 4
Rearward-facing in the back or front seat: preparation 5
Rearward-facing in the back seat: installation 9
Rearward-facing in the front seat: installation 12
Removing the seat 14
Forward-facing belt installation 15
Removing the seat 16
Positioning of the child 17
Sleeping position 18
Removing and refitting the cover 19
Cleaning instructions 21
Warning: potential misuse 21
Important advice 22
Point of sale information 23
Guarantee 24
It is important that you read this user manual BEFORE installing
your seat. Incorrect installation could endanger your child.
3 2