Dynex DX-L19-10A - Manual (Page 14)

Understanding the basics
11
Understanding the basics
Turning your TV on or off
To turn your TV on or off (standby mode):
1 Plug the power cord into an AC power outlet.
2 Press
(power). Your TV turns on.
3 Press again to turn off your TV. When you turn off your TV, it
goes into standby mode.
Warning: When your TV is in standby mode, it is still receiving power. To
completely disconnect power, unplug the power cord.
Note: If your TV does not receive an input signal for several minutes, it
automatically goes into standby mode.
Selecting the video input source
To select the video input source:
1 Turn on your TV, then press the INPUT key on the remote, or the
INPUT button on the TV. The INPUT SOURCE menu opens.
2 Press or to highlight the video source, then press ENTER.
You can also select the input source using the following remote
control buttons:
• COMP—Press to select Component.
• HDMI–Press to select HDMI.
• VIDEO—Press once to select AV1. Press twice to select AV2.
Press three times to select S-Video.
• TV—Press to select TV.
On-screen menu overview
Picture menu
Audio menu
Setup menu
Channel menu
Notes:
Depending on the signal source selected, you may see different options on
your screen. The above menus are shown in TV mode.
Menu items that are not selectable are grayed out. Menus in this manual
are described in TV mode, unless otherwise indicated.
The illustrations and screens shown in the manual are for explanation
purposes and may vary from the actual screens on your TV.
Parental Controls
DX-L15-L19-L22-10A_08-1840.book Page 11 Saturday, January 24, 2009 7:40 AM