DeLonghi 5500 - Manual (Page 12)

Descaling
1. Press the P button to enter the menu;
2. Turn the selection knob until "Descaling" is
displayed;
3. Press the button;
4. The message "Confirm?" is displayed.
5. Press the button to confirm (or the
button to cancel the operation);
6. Carry out descaling as described in the sec-
tion "Descaling" on page 19.
Setting the temperature
1. Press the P button to enter the menu;
2. Turn the selection knob until "Set
Temperature" is displayed;
3. Press the button;
4. Turn the selection knob until the required tem-
perature (high, medium, low) is displayed;
5. Press the button to confirm (or the
button to cancel the operation);
6. Press the button to exit the menu.
Auto-Off
1. Press the P button to enter the menu;
2. Turn the selection knob until "Auto-Off" is dis-
played;
3. Press the button;
4. Turn the selection knob until the required
number of hours of operation (1, 2 or 3) is
displayed;
5. Press the button to confirm (or the
button to cancel the operation);
6. Press the button to exit the menu.
Setting water hardness
1. Press the P button to enter the menu;
2. Turn the selection knob until "Water Hardness"
is displayed;
3. Press the button;
4. Turn the selection knob until the water hard-
ness measured using the indicator strip is dis-
played (see paragraph "Measuring water hard-
ness" - page 19);
5. Press the button to confirm (or the
button to cancel the operation);
6. Press the button to exit the menu.
Resetting factory default values
(reset)
This function resets the entire menu with the
default values (except the language, which
remains as set).
1. Press the P button to enter the menu;
2. Turn the selection knob until "Default Values"
is displayed;
3. Press the button;
4. The message "Confirm?" is displayed.
5. Press the button to confirm and exit
(or the button to cancel the opera-
tion);
Installing the filter
Certain models are provided with a water
softener filter (alternatively it can be pur-
chased separately from an authorized
Customer Service Center).
To install the filter, proceed as follows:
1. Insert the filter in the water tank as
far as it will go (see figure
alongside).
When you install the filter, you
must notify the appliance of its
presence.
2. Press the P button to enter
the menu;
3. Turn the selection knob until "Install Filter" is
displayed;
4. Press the button;
5. The message "Confirm?" is displayed.
6. Press the button to confirm (an aster-
isk appears at the top right of the display);
7. Press the button to exit the menu.
Replacing the filter ("Reset water
filter")
When the red light comes on, the filter must
be replaced:
1. Extract the exhausted filter and replace with a
new one;
2. Press the P button to enter the menu;
3. Turn the selection knob until "Reset Water
Filter" is displayed;
4. Press the button;
5. The message "Confirm?" is now displayed.
6. Press the button to confirm (or the
button to cancel the operation);
7. Press the button to exit the menu.
12