Cleaning and care of the unit, Replacing the fluorescent tube, Storage – Beurer TL 40 User Manual

Page 11

Advertising
background image

11

2

Enjoying the light

Sit as close as possible to the lamp, between 20 cm and 40 cm. You can go about your normal activi-

ties while using it. You can read, write, make telephone calls, etc.

• Every so often, briefly look directly into the light, since the effect results from the eyes/ retina recei-

ving the light.

• Use the brightlight as often as you want. However, the treatment is at its most effective if you carry

out the light therapy according to the prescribed time period of at least 7 successive days.

• The most effective time of day for the treatment is between 6am and 8pm

and we recommend that it is used for 2 hours per day.

• Do not look directly into the light the whole time you are using it, however, since that could lead to

overstimulation of the retina.

• Start with shorter periods of illumination, which you increase over the course of a week.

Note:

Eye aches and headaches may arise after the first times using the lamp. These will go

away in later sessions, as the nervous system will become accustomed to the new stimulation.

3

Important instructions

When using the lamp, maintain the recommended distance of 20 - 40 cm between your face and the

lamp. The duration of the application depends on the distance:

Distance

Duration

Up to 20 cm

½ hour/day

Up to 30 cm

1 hour/day

Up to 40 cm

2 hours/day

Basically,

the closer you are to the source of light, the less time you should use it.

4

Enjoying light over longer periods

Repeat your use of the lamp in the dark seasons for at least 7 successive days, or even longer, depen-

ding on your individual needs. If possible, conduct the treatment in the morning hours.

5

switching off the lamp

Press the On/Off button. The tubes turn off. Pull the mains plug from the socket.

CAUTION!

The lamp is hot after being used. Let the lamp cool off first long enough before you put it

away and/or pack it up!

7. Cleaning and care of the unit

The unit should be cleaned occasionally.

Important

• Ensure that no water penetrates inside the unit!

Before you clean the unit, always switch it off, unplug it and let it cool off.

• Do not wash the unit in a washing machine!

Clean using a damp cloth, to which you can apply a little detergent if necessary.

• Do not touch the unit with wet hands while it is plugged in; do not allow any water to be sprayed onto the

unit. The unit must be operated only when it is completely dry.

Do not use abrasive detergents and never immerse the unit in water.

8. Replacing the fluorescent tube

Only the following tube is approved as a replacement:

The manufacturer‘s tube is available with the order number 162.242 from customer support.

9. Storage

If you are not going to use the device for an extended period of time, disconnect it and store it in a dry place, out

of the reach of children.

Follow the storage instructions provided in the “Technical data” chapter.

Advertising