Beurer BY 52 - Manual (Page 13)

13
9. Disposal
In the interests of environmental protection, these devices must not be disposed of in the
household waste at the end of their service life. They should be disposed of at the appropriate
regional collection points.
Please observe local regulations when disposing of materials.
Please dispose of the device in accordance with EC Directive – WEEE (Waste Electri-
cal and Electronic Equipment).
If you have any queries, please contact the appropriate local authorities.
10. technical data
Operating voltage: 220–240 V ~ / 50/60 Hz
Power consumption: 80 watts
Heating time: 3 - 18 min.
Temperature for keeping warm: 35 °C - 85 °C
11. troubleshooting
Fault Cause Action
Water leaks from the bottom
of the device when in use. Device faulty Switch off the device imme-
diately, unplug it, let the
water drain out and return the
device to the retailer.
The warming process does
not start or does not end. Thermostat broken Switch off the device imme-
diately, unplug it, let the
water drain out and return the
device to the retailer.
No LED display Mains plug not (correctly)
plugged in or device faulty Check that the mains plug
is (correctly) plugged in. If
there is still no display, switch
off the device, unplug it and
return it to the retailer.
The baby food warmer does
not switch on once it is
plugged in. No electricity Check that the mains plug is
correctly plugged in.
The temperature on the
display does not increase
once the warming process is
started; the device switches
itself off after a while. No water in the device Unplug the device, let it
cool down, then fill it with
water and start the warming
process as described in these
instructions.
The food is not warm at the
end of the warming process. Not enough water in the
device Unplug the device, let it cool
down, then fill it with sufficient
water and start the warming
process as described in these
instructions.