Blackstar ID:15TVP - Manual (Page 5)

Factory Reset
The default factory patches and settings can be restored to your amplifier at any
time. Simply hold down the MOD, DLY and REV buttons simultaneously, whilst
switching on the amplifier. The bank LED will illuminate, and change from green, to
orange, to red, to indicate that a factory reset is imminent. This process will take a
total of two seconds. If any of the MOD, DLY and REV buttons are released before
the bank LED has cycled through all colours and switched off, then the operation is
cancelled and the amplifier will remain unaffected.
Once this is complete the amplifier will be in Demo Mode again.
IMPORTANT NOTE: This process will overwrite any user saved patches and
settings.
English
9
Demo Mode
When the amplifier is first switched on after purchase, or after a factory reset, it will
be in ‘Demo Mode’. The sound you hear will reflect the physical position of the front
panel knobs as it will be in Manual Mode. All effects, plus TVP, will be switched off.
All amplifier patch locations will contain Blackstar factory defaults. Patches can be
created and stored in Demo Mode but the original factory default patches and
settings will be restored each time the amplifier is turned off and turned on again.
To exit Demo Mode, hold down the Manual button (19) while switching the amplifier
on. The Bank LED (20) will change from red, to orange, to green and then turn off
to indicate that Demo Mode has been deactivated. If the Manual button is released
before the Bank LED has cycled through all colours and switched off, then the
operation is cancelled and the amplifier will remain in Demo Mode.
Blackstar’s INSIDER software can also be used to exit Demo Mode. From within the
program, right click on the Demo Mode label and select ‘Disable’.
English
8