Blackstar HT-5210 - Manual (Page 10)

10. Treble (OD Channel)
The Treble control allows exact adjustment of the treble frequencies within the
sound. At low settings (CCW) the sound will be warm and darker in character. As the
Treble control is increased (CW) the sound will become brighter. At the maximum
settings the sound will be aggressive and cutting.
11. ISF (Infinite Shape Feature)
The ISF control works in conjunction with the Bass, Middle and Treble controls. It
allows you to choose the exact tonal signature you prefer. Fully CCW has a more
American characteristic with a tight bottom end and more aggressive middle, and
fully CW has a British characteristic which is more ‘woody’ and less aggressive.
12. Reverb (HT-5R, HT-5RH and HT-5210 only)
The reverb control sets the overall level of the reverb effect. With the control fully
counter clockwise there will be no reverb. Turning the control clockwise will increase
the amount of reverb. The HT-5R, HT-5RH and HT-5210 feature digital reverb found
on the HT Venue Series and HT-1R, adding a rich depth to any playing style.
13. Power Indicator Light
The power indicator will light when the amplifier is switched on.
14. Standby
This switch enables the operation of the power amp stage and speaker output.
Always turn this on at least 30 seconds after the Power switch (15). For silent
recording or practise this switch should be put in the standby position. This will
disable the power stage, but the emulated output will continue to work.
15. Power
This switch is used to turn the amplifier on and off. You should always turn this
switch on before turning on the Standby switch (14).
Rear Panel
1. Mains Input
The supplied detachable mains lead is connected here. The lead should only
be connected to a power outlet that is compatible with the voltage, power and
frequency requirements stated on the rear panel. If in doubt get advice from a
qualified technician.
2. Speaker Outputs
For the HT-5210 the output marked ‘1x16 Ohm’ is for the connection of a single 16
Ohm external speaker cabinet. The outputs marked ‘1x8 Ohm or 2x16 Ohm’ are for
English
9