Blackstar HT Stage 60 - Manual (Page 7)

13 12
Technical Specification
HT Stage 60
Power (RMS): 60 watts
Valves: 2 x EL34, 2 x ECC83, 1 x ECC82
Weight (kg): 30.3
Dimensions (mm): 715 x 586 x 278
Footswitch: FS-7 included, optional FS-4 for Overdrive 2 Voice
HT Stage 100
Power (RMS): 100 watts
Valves: 4 x EL34, 2 x ECC83, 1 x ECC82
Weight (kg): 21.3
Dimensions (mm): 670 x 313 x 263
Footswitch: FS-7 included, optional FS-4 for Overdrive 2 Voice
.
5. Speaker Emulated Output
This output emulates the tonal characteristics of a guitar speaker cabinet and
provides a natural valve overdrive tone for connection to a recording device or
mixing desk. Always use a good quality screened lead.
NOTE: To ‘silently’ record, turn the amp to standby mode. You may also record
from this output while in standby mode without a loudspeaker connected, but
ensure that no loudspeaker leads are connected to any of the loudspeaker output
jack sockets of the amplifier, as this will defeat the load protection circuit and cause
damage to the amplifier.
6. Cabinet Switch
The switch enables you to select either a 4x12 closed back or a 1x12 open back
cabinet emulation for the Speaker Emulated Output.
7. Reverb Dark/Light
In the out position the digital reverb is voiced to have a warm dark quality. When
the Light position is selected the reverb has a brighter quality with more zing on the
reverb tail.
8. Effects Loop Return
Connect the (mono) output of an external effects unit here.
9. Effects Loop Send
Connect the (mono) input of an external effects unit here.
10. Effects Loop Level
The Effects Loop Level switch sets the effects loop to either +4dBV/-10dBV, which
enables you to use it with either professional equipment (+4dBV setting), or with
guitar level effects such as effects pedals (-10dBV setting).
11. Overdrive 2 Voice Footswitch
An optional 1-way latching footswitch (Blackstar FS-4 recommended) may be
connected here to allow the Overdrive 2 Voice function to be remotely controlled.
12. Footswitch
The supplied footswitch is connected here. The footswitch enables you to switch
between Clean, Overdrive 1 and Overdrive 2, and Reverb on/off.
English
English