Brinly DK-422LX Dethatcher Kit for STS-426LXH - Manual (Page 5)

L-1660-D 5
9
1
7
1
5
7
16
13
1. Lay the Tray (1) upside down. The front of
the Tray will have three sides (fl anges) facing
UP.
2. Assemble the twelve Wire Tines (7) to under-
side of Tray (1) as shown using 5/16” x 3/4”
Carriage Bolts (9), Special Washers (16 -
over “U” loops in Tines) and 5/16” Nylon Lock
Nuts (13).
NOTE: Center hole in back row of Tray (1)
(fourth hole from end) is for the pivot Bracket
later in Step 6.
3. With Tine Tips FORWARD and positioned
PARALLEL with front fl ange of Tray (1),
tighten all securely.
4. Feed and center each Safety Wire through
the two rows of Wire Tines (7) (inside of coils)
to opposite sides.
5. Using Pair of Pliers, bend both ends of each
Safety Wire (5) as shown in Fig. 2.
NOTE: Safety Wires connect all Wire Tines
together in case one loosens or breaks. A
safety wire must be installed through both
rows of tines as shown.
6. Attach Pivot Bracket (8 - short formed leg
against the tray as shown, long leg to face left
side) to center hole at back of the Tray(1)
7. Secure using 5/16” x 3/4” Carriage Bolt (9)
and 5/16” Lock Nut (13). Tighten securely.
8. Attach Lift Handle (6) to outside of Pivot
Bracket (8) using 5/16” x 1” Carriage Bolt
(10), 5/16” Flat Washer (12 - between Pivot
Bracket and Lift Handle) and 5/16” Nylon
Lock Nut (13). Tighten until Lift Handle is
barely free to move.
9. Slide Flat Grip (14) over end of Lift Handle.
Use Hardware Bags “A” & “B”
FRONT FRAME & LIFT ASSEMBLY
Figure 1
Figure 2
Figure 3