BUG-O Systems CB-1P - Manual (Page 7)

7
A B
WHEEL ADJUSTMENT:
The CB-1P Racking System (CWO-1670) and the Small Vertical Racker
(CWO-1685) are equipped with adjustable wheels. Always check these
components for proper wheel adjustment before using the machine. The
wheels need adjustment if you can cock or wiggle the components out of
alignment. The wheels should be snug but not prohibit movement along the
path of travel. The wheels with the hex stand off are adjustable. To adjust
the wheels loosen the hex bolt (A) until the adjustable bushing (B) can be
rotated. Correct the wheel alignment by rotating the adjustable bushing
(B). Once adjusted, hold the adjustable bushing (B) while tightening the
hex bolt (A). Recheck alignment.
WARNING: THIS MACHINE PRODUCES PLASMA ARC RAYS, IT IS NECESSARY TO USE
CORRECT EYE, HEAD, AND BODY PROTECTION.
MAKING A CUT:
1. Position the torch to the starting location using the Racking System (CWO-1670). Ensure that the
torch is at the appropriate position, standoff distance and angle.
2. Connect the ground cable to the work piece. The ground cable must make good electrical contact
with the work.
3. With the Arc “ON/OFF” switch in the “OFF” position and the “HAND/OFF/AUTO” switch in the
“HAND” position, set the rotation direction and speed.
4. With the Arc “ON/OFF” switch in the “ON” position the cutting process and rotation are both started
by throwing the “HAND/OFF/AUTO” switch to the “AUTO” position.
5. To stop the cutting processes and rotation, throw the “HAND/OFF/AUTO” switch to the “OFF”
position.
MACHINE CONTROLS:
Operational parameters can be set using the two control boxes attached to the machine as well as the
controls located on the power supply. Please refer to the sections in this manual.
• CWO-3951 Plasma Controls for descriptions of the control capabilities.
• CWO-6210 Rotation Control for descriptions of the various speed and directional capabilities.
• CWO-7655 Power Source Controls for descriptions of the power supply controls.