BUG-O Systems PBM-2000 - Manual (Page 7)

7
GENERAL SAFETY ADVICE
Beveling machine must not be used when:
1. The operator has not read the instructions and parts manual.
2. The work to be done is not in agreement with the recommendations in this manual.
3. The beveling machine in not complete or has been repaired with non-original parts.
4. The specifications of the power supply do not conform to those stated on the motor plate.
5. The operator has not checked the condition of the beveling machine, the condition of power cable,
control panel and milling inserts.
6. The power supply socket is not equipped with a protection circuit.
7. Bystanders are present in the immediate vicinity of machine.
Important rules of safe use of beveling machine:
1. Before attempting to work with the machine check condition of electrical components including power
cord and plug.
2. The beveling machine should be connected to an installation equipped with a protection circuit (neutral
or ground) and protected with a 16 A fuse – for 220V. When used on building sites, it must be supplied
through a separation transformer made in the second class of protection.
3. Machine can be used outdoors, but is not weatherproof. Do not expose to rain, snow or frost.
4. Do not use the machine in explosion hazard zones.
5. Always wear safety goggles and ear protection.
6. Do not remove metal chips with bare hands.
7. Inserts must be fastened firmly using lock screw.
8. If blade edge is worn, turn blade by 90° in a milling socket or change to a new one as described on pg.12.
9. Use tools recommended in instructions and parts manual only.
10. After work is complete, always clean metal chips from beveling machine.
11. Always unplug machine from the power supply during any work on the machine or when adjusting
angles.