BUG-O Systems CAS-2050 - Manual (Page 13)

13
PCB-1213 adJUSTMENT POT
adjustment Screw
The amp dial setting MdS aHC Remote Control (CaS-2051-10) may not exactly match the current
display on the power source. If precise matching is important, the user can calibrate the system so that
they match using the adjustment Pot (PCB-1213) found inside the Hall Effect Sensor Assembly (CAS-
1550).
While the system is welding and the AHC is “ACTIVE”, turn the adjusting Screw using a small
“Jeweler’s Style” screw driver.
As this screw is turned, the current display on the power source will change. When the display on the
welding power source matches the amp dial setting, the system is calibrated.
NOTE: This adjustment is not normally needed.