18a 18 – Campomatic DW816I User Manual
Page 3
12345678901
12345678901
12345678901
12345678901
12345678901
12345678901
3
GB
Description of control buttons and indication lights
1
3
4
4
2
4
4
3
1) On-Off buttons
On/Off – Press this button to turn on the
appliance.
2) Indication programme LED
It is illuminated when the appliance is turned on.
3) Programme selection button
4) Start-Stop/Pause programme button
- ON/OFF
5) Low salt indicator (if included)
6) Low rinse aid indicator (if included)
7) Door handle
To open pull forward (an electric safety
mechanism turns off the machine when the door
is being opened).
4
Start
After checking the quantities of regeneration salt (only in the salt container version)
and of rinse aid,
open the water faucet completely, place the dishes in the baskets, fill detergent into the detergent
container and add also detergent for the pre-wash (if necessary); then close the front door.
Now proceed as follows:
• Press the “ON-OFF” button , “The LED corresponding to the last wash cycle performed lights up”.
Wash cycle selection
• When you press the button for the first time, you confirm the wash cycle that corresponds to the
flashing LED . The next times you press the button, the LED of the programme that corresponds to
the wash cycle you intend to select will light up. At the end of the cycle, the selected programme flashes.
Select the programme which you believe is best suited to the types of dishes which need to be washed.
Start Button (Model illustrated in fig. 18)
•
Press button with the appliance door shut, the dishwasher wash cycle will start and the LED of
the button itself lights up.
Start Button
(Model illustrated in
fig. 18a)
• Press button and close the door at the front of the machine to start the wash cycle.
Incorrect setting of the programmes (programme change)
• To modify a wash cycle in progress, you must press the Start button for approximately 6 seconds;
subsequently, the LED of the selected programme begins to flash. The RESET phase will end when
the Start button LED goes off. At this point, the appliance is ready to be set again.
• If you forget to put a dish in, you can interrupt the wash cycle (preferably only if it hasn’t been running
for long) by pressing the Start button which then flashes; open the appliance door and place the
dish inside. To restart the appliance, close the door and press the Start button again; the cycle will
resume from the point in which it was interrupted.
• To repeat the same cycle, press the programme button and then the Start button .
N.B. The buzzer will sound (3 beep) to indicate the end of the RESET.
Stop
After the wash cycle the dishwasher will stop automatically and will emit a sound signal of 3 beeps (only
for the intermediate version), and the LED for the selected programme will flash. To turn it off, press
the button on/off. After each wash cycle, the water faucet must be closed to insulate the appliance from
the water supply system.
ADVICE: To speed up drying, the front door may be left ajar.
5
6
1
2
3
4
18a
18
2
7
5
6
3
4
1