Campomatic KI590TSL - Manual (Page 8)

The appliance has been manufactured as a class I, therefore earth cable is
necessary.
The connection to the mains is carried out as follows:
If not provided, connect a plug for the electrical load indicated on the
description label. Where a plug is provided,
the cooker hood must be installed in order that the plug is easily accessible.
An omnipolar switch with a minimum opening of 3mm
between contacts, in line with the electrical load and local standards, must be
placed between the appliance and the network in the case of direct
connection to the electrical network.
• The minimum distance between the support surfaces of the cooking pots on
the cooker top and the lowest part of the cooker hood must be at least 65 cm.
If a connection tube composed of two parts is used, the
upper part must be placed outside the lower part. Do not connect the cooker
hood exhaust to the same conductor used to circulate hot air or for
evacuating fumes from other appliances generated by other than an electrical
source. Before proceeding with the assembly operations, remove the
anti-grease filter(s) (Fig.12) so that the unit is easier to handle. In the case of
assembly of the appliance in the suction version prepare the hole for
evacuation of the air.
• Hood assembly
Remove the structure from the packaging and separate the upper part from
IEC227 North America
L=live Brown Black
N=neutral Blue White
E=earth Green/Yellow Green