Campomatic PI200 - Manual (Page 7)

6
3. Press SET key to confirm and exit.
At on-hook state, press FLASH key to enter LCD contrast setting directly, then press
FLASH key continuously to adjust the LCD contrast.
¾ Setting Alarm Clock
1. In on-hook state, press ALARM key once, LCD displays 12-00 AL1,
2. Press Ÿ or ź key to select ON or OFF. LCD displays “ALM” icon when the alarm is set to ON.
3. Press SET key, value “12” starts to flash.
4. Press Ÿ or ź key to set the alarm hour and press SET key to confirm and enter alarm minute
setting.
5. Press Ÿ or ź key to edit alarm minute and press SET key to confirm and go to next group
alarm clock setting.
6. Repeat the above steps to set additional alarms.
NOTE: The first 3 groups alarm clock will be repeated periodically every day while the last 2 group
alarm clock is effected one time.
SECRET CODE SETTING AND REMOTE MONITOR FUNCTION
¾ Setting
1. In on-hook state, press and hold RING key for 3 seconds, LCD displays Pin ----.
2. Input a 4-digit of PIN using the numeric keys.
3. Press DEL to edit the secret code, press SET to confirm.
4. When the last digit of the secret code is #, the telephone will activate remote monitor function.
5. Set the ringer to OFF. (Please refer to section “SETTING RINGING TONE”).
¾ Usage
1. Secret code: When caller call this telephone, he/she will hear the usual ringing tone (when
the line gets through) three times or four times. However, the telephone unit will not ring. The
caller will hear a short “di” sound, which means that the caller need to key in the secret code.
Once the caller keys in the correct code, the telephone unit will ring. Press key or pick up
the handset to have the conversation with the caller.
2. Remote monitor: If the last digit of the secret code is #, after the caller keys in the correct
secret code, the telephone unit will go into handsfree mode automatically.
3. If the caller keys in the wrong code, he/she will have to call again and key in the correct secret
code PIN.
NOTE: This function is useful only when the telephone ringing is set to OFF. The caller must know
the secret code in order to dial through the line.
TRANSFER BETWEEN PARALLEL PHONES
¾ Setting paging number
1. In on-hook state, press and hold SET key, LCD displays EL--